OskooI_007 Hi, hope you are doing well.
I ran into the same issue frequently, I just keep suffering from CFS and TN when there is many members in a game.
Below is my screenshot:
In this game, my TN frequently elevated to 300+ (although it was only 89 at the moment of the screenshot). However, my CPU frame rate was quite high (111/9.0), so did GPU one (112/8.9), based on upper right performance statistics. Hence, it looks like neither CPU nor GPU issue.
I am confused and not able to figure out how to decrease the CFT to get a better TN.
Following is the system summary from the HWinfo.
I appreciate any advice.
toratorafly hello! Simulation (SIM) is below 60fps and that's the reason time nudge (TN) is spiking to a high number.
Everything looks good in your HWiNFO system summary. Memory is in dual channel mode with low timings and 3200MHz.
Run BF6 in Windowed Mode (alt + enter) so you can see HWiNFO. Watch CPU temperature and frequency. See if the CPU frequency is dropping below 3.7GHz. Also check if the CPU temperature is going above 90°C.
If I don't reply to your post then personal message me. Sometimes the forum fails to notify me when someone replies.
OskooI_007 Thanks a lot for taking look at this.
Today I ran into another high TN game.
From the screenshot you can see the TN were usually higher than 200.
I recorded the CPU temp and Core frequency (button one, sry the title is in Chinese) as you advised. The temp was around 58℃ stably and Core frequency always stayed 3.7 GHz.
I also checked the CPU usage, and it's 70%-80% which is quite reasonable. Hence, it's really not like a CPU issue from my pov.
Moreover, the dedicated VRAM was about 7.9/10GB, so it shouldn't be a VRAM issue too.
Is there anything else I can check? I noticed my "mp/s" in upper right was always red. Will this cause problem?
Btw, I saw you mentioned the high TN was caused by 60> Simulation (SIM). Could you clarify what SIM actually is? It's always around 60 in games and 30 in the menu. Looks like it's throttled to a certain threshold. Is there a config I can change to increase the threshold?
Much appreciate your help.
