I'm a little bit confused about something, Bun ....
7) Now, pay close attention to what you need to do here!
Ctrl+Shift+Click each first Processor...
»
You need to do this part carefully.
If you have more than one switch, here is how you set this up:
Link the first Second Processor that you use to the central or extra Processor that doesn't correspond with any other Processor, Floor Switch, or Pushable Statue...
»
Then, link the second Second Processor that you use to the same extra additional Processor...
»
Link the third Second Processor (if you have one) to the extra Processor...
»
If you have them, link the fourth Second Processor to on the extra Processor.
Fifth Second Processor to .
Sixth Second Processor to .
Seventh Second Processor to .
And the eighth Second Processor to .
What do I do after I've done the Out 0 for the first processors? If I try to click any other processor, it wants an IN input ...
God Bless,
mik
