Forum Discussion

Rallyjacob04's avatar
Rallyjacob04
2 years ago
Solved

It does not approve the Fanatec Handbrake on PS5

Hello. It does not approve the Fanatec Handbrake on PS5. When I have selected it and want to pull the handbrake when i launch the car, nothing happens. The car just stands still, and i can’t move. Bu...
bug
  • Schoschone13's avatar
    Schoschone13
    2 years ago
    I had the same problem. Take a look at your settings and calibrate the steering wheel, pedals and handbrake again. Eighth at the handbrake on whether it works without operating. For me, it was at 28% effect even though I didn't even touch it. Then I put the dead zone higher than the effect is and now it works perfectly.
rhswhodareswins's avatar
rhswhodareswins
2 years ago

I have the same problem! I can't even bind my Fanatec handbrake CS 1.5; when I just slightly move my handbrake to bind it, I get a message that the driving device is disconnected. Only after I release the handbrake the message dissapears. No problem with other race titles like Dirt Rallt 2.0, GT7 or even The Crew Motorfest. Please give us a patch asap, the game is barely playable now caused by the many hairpin corners in the game...

MrSlapp1's avatar
MrSlapp1
2 years ago

100% FIX

Open it and tighten the nut on the yellow damper thing. Keep tightening it a lot, then it works. You can keep turning it and it makes the handbrake travel shorter and tighter but now it works. If the nut is not tight enough, it emits a signal already. Fixed it like that.

About WRC Technical Issues - Archive

1,959 PostsLatest Activity: 5 months ago