VR Feedback - Multiple Headsets
Played on a 3080Ti/10700K Valve Index / Quest 2 / Pimax 8KX 1. The TAA + FidelityFX sharpening NEEDS some kind of sharpening slider for extra sharpening because it's still not sharp enough as it i...
Forum Discussion
@TheKenarf By any chance is the game in fullscreen on your normal monitors? If so, when the game is trying to load up, hit Alt+Enter and see if it begins to load normal
It wasn't showing on the other monitor.
I think i found one thread with the fix, i deleted the "hardware_settings_config_VR" in dcouments/mygames/f122 and it solved the issue. if anyone has the same problem that should help
.
Now i have to find why steamVR crashes after 1 minute 😛 i think it's related with the PiTool program
Attention Oculus CV1 Users:
I have found the magic sequence that makes the CV1 work.
You have to be inside the goggle for this to work. If you have black screen problems, select VR VERY LOW (the lowest setting) and apply. Don't restart the game, immediately go to the screen with the Anti Aliasing settings. Toggle between the modes, there is a high probability that the graphics will suddenly appear. If it does not, make sure your resolution is set to 1280x1024 and always in WINDOWD mode. The 1st AA setting yields top FPS, the second is bad FPS and the 3rd is black screen.
If it fails select other VR modes then back to the lowest one then AA toggle again.
This is the only way to get the CV1 to work.
Once the trick works, you can adjust all the settings in any way like you normally would. It just needs that kick start to work. Every time you launch the game you have to go through this sequence of steps.
On 1080ti with Oculus CV1 on 1920x1080 Medium VR you get smooth gameplay and very good quality (no blurring).
