Acceleration stuck from start of game!
i bought this game, start play and in the 1st mission i cant move! always handbrake!!! can sombody help me! pls!
Several solutions to this issue are being offered in the following threads:
Forum Discussion
these ways dont help me! fix it! and my car cant move just stuck like always handbrake!
ruslan4ek9,
What controller(s) do you use. I use a Playstation 4 controller with DS4Windows. I had a similar issue as you described, even with a keyboard and Xbox One controller. Reinstalling the game fixed it. But the fix only lasted a few minutes. However, this is the solution that worked for me - I uninstalled the xbox 360 drivers that allow DS4Windows to emulate the Xbox controller. I have had no issues since then. Hope this helps.
Straatford87DICE Team
Several solutions from the aforementioned topic:
- Yes! I was about to give up on this, and the answer is so simple! Move accelerator dead zone to the middle in the sensitivity settings. This fixed both my accelerator being stuck and the car not being able to go above 60 or so mph. THANK YOU!
- I had vjoy drivers installed and when I uninstalled them it worked for me.
- UNPLUG ALL your controllers EXCEPT your keyboard and TRY again
-
I had the same problem and could solve it now.
Try checking controller > tuning and make sure that the sliders are in the middle position. For me all of them were completely turned down for some reason.I don't know why this even affects keyboard controls, but it does. Hope it works for you guys too.
-
I did something reminiscent of what you said.
And thanks worth you suggested some of the works now perfectly.
could easily run 140 km/h when I tested it quite quickly.My settings are.
Accelerator dead zone 100%
Break dead zone 100% - I was playing around last night, and found that if you go into your controller settings (on NFS game) and un map every command for all other devices (keyboard & steering wheel) you can then play the game fine using your controller. I'm using dualshock 4, and this worked for me. Also make sure to turn up your sensitivities, while leaving your dead zones turned down.
- Yes! I was about to give up on this, and the answer is so simple! Move accelerator dead zone to the middle in the sensitivity settings. This fixed both my accelerator being stuck and the car not being able to go above 60 or so mph. THANK YOU!
Featured Places
