Porsche 911 GT2 and GT3 silly rake when using off-road parts
Product: Need for Speed Heat
Platform:PC
Summarize your bug When upgrading the Porsche 911 GT2 and GT3 with max offroad parts, the car gets silly rake.
What car were you using? Porsche 911 GT2 and GT3
Was the car your own build or downloaded from the in-game community? Personal Build
What was the last event you played? N/A
Was it a day or a night event? Day Event
How often does the bug occur? Every time (100%)
Steps: How can we find the bug ourselves? Build Porsche GT2 and GT3 with offroad parts
What happens when the bug occurs? The car gets a lot of rake (front is lower than rear by a lot)
What do you expect to see? front is just a bit lower than rear or about the same
As you can see, the 911 GT2 and GT3 has rake issues when putting offroad parts on it.
(the front is way lower than back when it should be equal or just a bit less)
This rake issue with offroad also happens to a few other cars like the NSX2015, E46, S2000, Testarossa and 180SX, etc. all of which have a slight reverse rake (the back is lower than front).
Additionally, the Aventador, 718 Caymen, and a few others don't get lifted enough - about a less hyper/super/sporty car vs a 'road'/road/rally car - when using all offroad parts (they still work offroad, it just looks sillier than if it had more lift).
I suspect this is because the parts 'amplify' the inherit stance when lifting, and therefore would cause any slight changes to be exaggerated.
(Check all the cars with offroad parts if need be...)
The attachments are the 180sx and E46 with horizontal red lines drawn in paint as a rough reference.
And as you can see, the back is just a tad too low (much less serious than the GT2 and GT3 that now look like a dragster though).
