Community Manager
Community ManagerSetting up a Session (Rallycross)
From the Main Menu navigate to the Freeplay tab > select Custom > then select Create Championship
Navigate to the Multiplayer Settings tab > set Session Visibility to Private and Entrants to Humans Only. Hit the [Apply] Button to confirm.
Select the Add Event tile > Choose your preferred Rallycross location > set the Format to Single Race > set the desired vehicle class, weather and laps and hit [Confirm].
Once all stages/events are setup and confirmed, your players should navigate to the Freeplay tab on the main menu. They should then use Find Game menu option and select your Lobby. If players cannot join the Lobby in this way, invite them manually (same process as mentioned in the Rally section above)
The host (primary spectator) and secondary spectator should navigate to the Lobby tab, highlight a player, press the Player Options button prompt (Y/Triangle) and select Start Spectating Player.
Spectators will be denoted by an eye symbol which will appear next to their username. The host will be denoted by a crown symbol. The host can now navigate back to the Championship Configuration tab to start the championship.
Community ManagerChanging grid positions in Rallycross
In the lobby the player who initially creates the session (the host) will be able to move the player order around before launching into a session.
This will be used for grid positioning in Rallycross events where the grid order will be directly affected by the order in which the players appear in the lobby. The driver at the top will be in Pole Position.
The host can change this order by using the left and right directional buttons to move the highlighted player up or down in the lobby list (in the example above, PJ Tierney the Host has pressed right to move himself further down the order).
Note that spectators will be unaffected by this ordering system. Therefore, it makes sense to move both spectators to the bottom of the list, so that they can be easily identified and not confused with players.
Community ManagerUsing Trackside Cameras
After entering the session as a Spectator and a race/Stage begins, the camera view can be changed at any point by the spectator.
To access the Trackside Camera it requires the spectator to switch to the Roof Camera using the left and right bumper buttons (LB/RB on an Xbox controller, or L1/R1 on PlayStation) and wait a few seconds until the trackside camera triggers.
Helicopter cameras are not available, and any instances where a helicopter camera would normally be used in Single Player are replaced by a "chase" camera that follows the car.
Community ManagerUsing Broadcast Mode
During a Stage/race spectators will have access to the Broadcast menu on the bottom right of the screen. This will appear when a button is pressed and will fade away to become invisible after a few seconds of inactivity.
Broadcast Mode can be toggled via a context menu. This allows the Spectator which players or camera angles without needing to have the menu visible, which is useful for when you don't want to show menus in livestreams.
To enable Broadcast Mode use the context menu shown above, pressing X/Square to open said menu. Enable Broadcast Mode with the left/right directional buttons and wait a few seconds for the menu to disappear.
To turn off Broadcast Mode press X (Xbox controller) or Square (PlayStation) to make the menu appear again, and toggle it the same way as above.
Note: Spectators with Broadcast Mode enabled should refrain from pressing the back button (B/O). Doing this will result in the Spectator being taken to a screen where they are no longer spectating. If you do this by accident, press X/Square to start spectating again.
Community ManagerSpectator Controls
The image above shows the button layout and its corresponding on screen menu element whilst spectating. If you're using a PlayStation controller the buttons in the similar positions do the same thing as the Xbox example shown here.
