Trying to get the controls mapped in game. Iv'e got about 6 controllers on my computer, however, I cannot get SW Squadrons to use the correct three controllers. The Flight Stick Devices I should have in there are
However, it has latched onto the vJoy Device like grim death and will not consider using anything else. Unplugging things just moves the controllers I need further from the top three devices, and break other systems I've got set up, so it's not a great option here.
Suggestions for getting this thing to let me map the right Flight Stick Devices? Right now I'm dead in the water.
Thank you,
Harry Voyager
Same joystick, same pedals.
So far i cannot get yaw left to accept input setup if yaw right is setup and vice versa. To get round this (for now) I am using the brake function.
On the first (proper) mission the only input that is accepted is roll.
Fully concur with the above.
CH Pro Throttle
CH Combat Stick
Above being used in "mapped Mode" via the CH Control Manager generate 6 virtual devices. I also have a game pad and rudder peddals (that is a total of 8 if anyone wasn't counting)
Device list in game only supports 4 controllers.
Oddly, the game chooses to allow me to only select from 1, 6, 3 and 5 from the CH devices. This limit of 4 devices is VERY familiar if you use Teall joystick virtual overlay as javascript / browsers are HARD CAPPED at hooking into the FIRST 4 devices detected.
Lets hope the Devs are not using the same methods.
I also have the rudder issue. Rudder input is only recognized as a single direction. So either Yaw + or -. Input mapping needs some work.
My setup:
- Virpil Warbird Base with TM F-18 stick
- Virpil MongoosT-50CM2 Throttle
- Simped Rudders
