Can’t Save Platformed Rooms

You could lower the platform to normal floor and leave instructions which parts should be raised platform. Unfortunately, platforms are their own rooms, so a room with a platform is actually two rooms.

I have a workaround idea that may or may not work:

Don't use the platform tool to make your platforms. Instead, use the room tool to make your full-sized room and then use a low fence to border out where you want to put a platform, then click inside that section and use the arrow keys to raise/lower that platform. Then once you have the platform made, delete the fencing around the edge of it. As a final step, you might also have to use the room tool again to retrace around the same footprint of the original room walls (which will delete all your wallpapers by the way).... and hopefully that won't delete the platform (I've never done it so I'm not sure)?

If all goes right, this trick might still read it as the one room? But I'm not 100% positive on that since I don't ever make or save premade rooms.

"AncientMuse;c-18097831" wrote:
I have a workaround idea that may or may not work:

Don't use the platform tool to make your platforms. Instead, use the room tool to make your full-sized room and then use a low fence to border out where you want to put a platform, then click inside that section and use the arrow keys to raise/lower that platform. Then once you have the platform made, delete the fencing around the edge of it. As a final step, you might also have to use the room tool again to retrace around the same footprint of the original room walls (which will delete all your wallpapers by the way).... and hopefully that won't delete the platform (I've never done it so I'm not sure)?

If all goes right, this trick might still read it as the one room? But I'm not 100% positive on that since I don't ever make or save premade rooms.

After an attempt, I've found it works only when the platform does not touch the walls of the room. Thank you!