Forum Discussion

d06133583e413aa's avatar
d06133583e413aa
2 years ago

Bindings for handbrake

I’m on PS5 using a Fanatec GT DD Pro wheel. I want to use the clutch pedal as my handbrake, so I unbind the clutch then I go to the handbrake and bind it to the clutch pedal. 
But when I try and drive, even when it’s in gear and I press the accelerator, the car won’t move.  If fact if it’s on a slope, it will roll forward/backward.  Not sure why it’s not working - I was able to do this in Dirt Rally 2.0 no problem. 
one thing I noticed when unbinding, there were 2 options: unbind or unbind action. Not sure how they are different. 

bug

6 Replies

  • Mr_Citizen93's avatar
    Mr_Citizen93
    2 years ago

    Problems with the Fanatec's handbrake. If I use it, the gears don't go in, as if I were pressing the clutch. The engine revs but doesn't run. When I disconnect it works perfectly. I have tried two wires, including a new one, and nothing. I play in ps5 too.

    The problem is the handbrake 100%

  • Schoschone13's avatar
    Schoschone13
    2 years ago

    Look at your settings. My handbrake is on 28% when I was Not Touch the brake. I set the Death Zone up to 31% and now it Works Perfect at the start and all over the Stage. 

  • Mr_Citizen93's avatar
    Mr_Citizen93
    2 years ago

    My handbrake is correctly set. When the car doesn't move, it isn't because the handbrake is acting, the light is off. It's as if the clutch was depressed.

  • Schoschone13's avatar
    Schoschone13
    2 years ago

    That's how it was with me that the light of the handbrake was off. Really look in your settings and calibrate everything again. Only then did I see that my handbrake was at 28% effect.

About WRC Technical Issues - Archive

1,959 PostsLatest Activity: 5 months ago