Product: EA SPORTS™ WRCPlatform:PlayStation 5Summarize your bug Start of timetrial/stage card keep revving but won’t moveHow often does the bug occur? Often (50% - 99%)Steps: How can we find the bug ourselves? Start stage on ps5 with dd pro and Fanatec hbWhat happens when the bug occurs? Nothing, keeps revving after let go of handbrake (hb signal is off) won’t move/start stageWhat do you expect to see? That we start the stagePs5 fanatec GT dd pro with handbrake and Fanatec pedals

I had the same problem. Take a look at your settings and calibrate the steering wheel, pedals and handbrake again. Eighth at the handbrake on whether it works without operating. For me, it was at 28% effect even though I didn't even touch it. Then I put the dead zone higher than the effect is and now it works perfectly.

Cars won’t start at stage | EA Forums

15 Replies

IronValkyrie
2 years ago
@Twanner73 I have this issue on my DD1. All inputs are recognised - brake, steering, handbrake, gears etc. but the car won’t move.
Petelb2611
2 years ago
Me too same thing, car will go reverse but wont go forward, and the RPM wont get high either.
Schoschone13
2 years ago
I had the same problem. Take a look at your settings and calibrate the steering wheel, pedals and handbrake again. Eighth at the handbrake on whether it works without operating. For me, it was at 28% effect even though I didn't even touch it. Then I put the dead zone higher than the effect is and now it works perfectly.
Twanner73
2 years ago
Did calibration, handbrake shows 0%. Even if deathzone on 10% still not works.
Rallyjacob04
2 years ago
Me too
taffy70
2 years ago
Seems to be a handbrake issue, I unbound my handbrake and the car drove again. I have the Fanatec gt did PlayStation wheel col pedals, handbrake and shifter.
Schoschone13
2 years ago
@Schoschone13 schrieb:
I had the same problem. Take a look at your settings and calibrate the steering wheel, pedals and handbrake again. Eighth at the handbrake on whether it works without operating. For me, it was at 28% effect even though I didn't even touch it. Then I put the dead zone higher than the effect is and now it works perfectly.
Do This… EA has confirmed it as a recognized solution.
gosta68
Seasoned Novice
2 years ago
It’s just reverse that’s works on some stages ??
DevilDuck3381
Rising Novice
2 years ago
@Twanner73 Do you have a handbrake? If so, try the following:
1) First try removing it from your setup (simply unplug it) and see if the issue persists. If so wait for a bug fix. If your cars now launch properly, move onto the next step.
2) Go to your assists and towards the bottom, make sure the launch assist is turned off. This automatically holds the handbrake down before you launch your car. You want to make it so you must hold the handbrake down to get the countdown to start.
3) Reconnect and recalibrate your handbrake in the options.
4) Start a new rally and observe if the countdown starts automatically. If so, the game is detecting your handbrake as being held down even if it reads at 0% in the calibration menu.
4) Adjust the deadzone of the handbrake until the game stops detecting it as being held down upon launching the car. For me, I merely had to set the handbrake dead zone at 1.
lzj3thv75tih
2 years ago
I'm having the same problem with a DD Pro and handbrake on PS.
It's only affecting H2 and H3 RWD cars. But it is the clutch stuck on and the car won't move at the start except roll with the gradient at the start line. It revs, changes gear but won't move.
Every other class of car is fine and works as expected.