Forum Discussion

Re: Bindings for handbrake

Problems with the Fanatec's handbrake. If I use it, the gears don't go in, as if I were pressing the clutch. The engine revs but doesn't run. When I disconnect it works perfectly. I have tried two wires, including a new one, and nothing. I play in ps5 too.

The problem is the handbrake 100%

5 Replies

  • Schoschone13's avatar
    Schoschone13
    3 years ago

    Look at your settings. My handbrake is on 28% when I was Not Touch the brake. I set the Death Zone up to 31% and now it Works Perfect at the start and all over the Stage. 

  • Mr_Citizen93's avatar
    Mr_Citizen93
    3 years ago

    My handbrake is correctly set. When the car doesn't move, it isn't because the handbrake is acting, the light is off. It's as if the clutch was depressed.

  • Schoschone13's avatar
    Schoschone13
    3 years ago

    That's how it was with me that the light of the handbrake was off. Really look in your settings and calibrate everything again. Only then did I see that my handbrake was at 28% effect.