Dwarf Noble - Can't talk to gorim in prison??

On windows 11, with v sync already enabled and Gorrim was still stopping short. I tried going into the corner, zooming out the camera and trying to talk to gorrim and it worked instantly. 

There are actually a few times this can happen throughout the game. NPC movement bugs are something you'll run into along the way and the best way to fix the issue is to load to a previous save just before the movement bug. As soon as you see the NPC in question begin to move along their programed path, save immediately. Now load that save and you should see the NPC begin to move along their path normally. Took me a couple of tries in the Noble Dwarf storyline but I managed to talk to Gorim. Repeat this method whenever the movement bug pops up again in the game. 

On full HD, activating V Sync works. 

TLDR for ultrawide users:

Windows settings: 2560x1080 resolution with 60Hz refresh rate

Game settings: 1920x1080 resolution with v-sync ON.

To add to this, v-sync on does not seem to be the only thing required. I am on an ultrawide with a resolution of 2560x1080 and a refresh rate of 144Hz. For me, the fix was to use the in-game settings for v-sync set to ON and a game resolution of 1920x1080. Then I had to drop my Windows display settings to 60Hz refresh rate on my ultrawide, keeping 2560x1080 Windows resolution. If I kept 144Hz, then when the game launched it would not fill the entire monitor and left vertical black bars on the left/right side, and Gorim would not walk far enough. If you have vertical bars, drop your refresh rate to 60Hz in Windows and that should get you fixed up.

However, with these unnatural settings, the dialogue options don't show for the ensuing conversation. To get them to show, you can toggle back and forth between windowed and fullscreen mode by using the Alt + Enter keybind each time options are presented to you.

Guys, this worked for me: Steam ultimate Edition Windows 10:

http://dragonage.wikia.com/wiki/Console_(Origins)

Enable console first and then use this command:

runscript zz_talk_nearest

copy and paste doesnt work, so you will have to type it, also check if console is enabled by pressing C for Character before, if the Charpage doesnt open the console is running!

bump 2020 same issue, was on virt sync and encountered it, turned it off and on right before, still the same.

I found the solution! Use the console command: runscript rubberband

The trick is to get your frames at 60 or below. The event of him walking to the cell door is tied to the frame rate, so if you're above 60, he stops short. Typically V-sync will lock to 60, but it might not. You can set the framerate cap to 60 in the nvidia control panel. not sure how to do this for AMD

I changed my resolution, and that is what worked for me. No clue why.