Can't Make Stairs Even With Wall?
i am trying to figure out how to make my stairs even with the wall and add a fence to the bottom of the stairs
I didn't realize that the lower level was a basement. I should have though. My bad. Thanks for the pics and the additional information. That said, the cause of your problem is the foundation as that adds depth to the basement so the stairs will not place the same as if you were going from a 2nd floor to the 1st floor of the same height.
I watched the speed build video a couple of times. I could not find where the top of the basement stairs began anywhere. He didn't show it. But it's evident by your first pic that there is no foundation above the basement. I know at least one way how to do that but didn't see it done in the video, so I wasn't sure how he did it. So, I did a search of the Gallery and found the build, downloaded it and now see how he did it. What was confusing me is the house is on a raised foundation. Normally, when you put a basement under a foundation, you get the gap that you have between the floors. But that only happens under a full basement. His basement is only partial and does not extend to the edges of the house above. So, in that case you can raise the basement using the big double headed arrow and get the top of the walls to reach the floor above so there is no gap, just like what happens when you build a flat foundation, without raising the terrain outside.
So, if you are trying to replicate that house as he built it, just grab the arrow and drag the basement up. Then the stairs and fence will match up and be in the right place. You might find it helpful to download the lot and take a look at it. His username in the Gallery is MrOlkan and the name of the lot is ModernO. It looks like it's a popular lot according to the likes and number of downloads.
Hope this helps.
